Magnetically Coupled Waterproof Servo Prototype

 


A critical component of our Microtransat boat(s) is the actuators for rudder, wing sail, etc.  On the hunt for a rugged, waterproof and flexible solution I've been working on a prototype that uses a magnetically coupled output stage to keep the delicate motor, gearbox, and electronics completely waterproof.

Comments

Post a Comment

Popular posts from this blog

Waypoint Navigation and Sailing Algorithm

Image
This post describes the underlying operation of the Sailing algorithm built into the DroneLink platform.  The functionality is spread across a number of logical modules, allowing for flexible usage in different types of devices, for example, motorboats requiring waypoint navigation, but not sailing logic. Waypoint Navigation All our boats (and other mobile robots) require basic waypoint navigation, implemented in the Waypoint module.  The module loads a list of lon/lat coordinates and associated target radii from a CSV stored in the ESP32 flash filesystem (waypoint.csv).  An example CSV and the resulting visualization is shown below for 4 waypoints: The Waypoint module subscribes to t he current lon/lat location,  from the GPS module, and uses this to calculate once the boat has come within the target distance of the current waypoint (10m radius for the first waypoint in the example above).  Once the target radius is reached, the next waypoint from the file w...
Read more

Volantex Compass Robotic Conversion

Image
Motivated by the desire for a compact, traditional sailing boat that I could easily chuck in the car and launch with minimal prep, I acquired a second-hand Compass Volantex DG65-class RC yacht.  The previous owner had assembled it from a kit, but never quite finished the rigging.  So, having completed that little task I took it out for a sail using the included 2-channel RC transmitter.  This test sail verified it behaved nicely on the water and gave me a sense of how it might behave after conversion to robotic control!  The conversion would involve a few stages: Replace the original RC receiver and battery with a DroneLink motherboard, Power module and LiPo battery Rework the electronics bay to accommodate the electronics Replace the stock hatch with a new 3D printed hatch to house the battery and Compass module Integrate a GPS antenna and 915MHz dipole for the RFM69 radio Create a miniature wind vane using an AS5600 magnetic encoder  Overall layout: New Brains...
Read more

DroneNode Motherboards - Evolution from v1 to v5

Image
Each boat (or other device) is based on a custom ESP32-based motherboard running our DroneNode firmware.   The motherboard exposes the ESP32 IO interfaces (digital/analog IO, serial, SPI) and includes an 8-channel I2C expander to make connecting peripheral devices extremely easy.  It has also evolved to include onboard GPS, RFM69 radio, QMC5883L compass, status Neopixel and micro-SD card reader as of v4. The same DroneNode firmware runs on all versions of the motherboard, maintaining backward compatibility and auto-detects hardware version based on an I2C scan of onboard devices. See DroneLink Architecture for how the motherboards fit into the overall DroneLink ecosystem. Version 1 - Simple beginnings Our first attempt at a motherboard to support early test boats (like the Paddles ) - calling it a motherboard is a stretch, given it was really just a breakout board for an ESP32 DevKit, an I2C multiplexer, and a bunch of connectors for expansion ports / I2C. Its simplicity ...
Read more